Results 1 to 2 of 2
  1. #1
    Member
    Join Date
    Apr 2017
    Location
    Indianapolis
    Posts
    105

    Hydrowave or Other Accessory Mount Idea

    Due to having an 18ft boat I don't have a ton of room on the front deck, and cramming this hydrowave unit over by my trolling motor was going to make the wiring a mess. I had the idea of sandwiching a piece of aluminum flat roll between my ram mount and one of my graphs. I started with a section of 1/8"x2" aluminum and cut it with a jigsaw, sanded down the corners, marked and drilled. Obviously you wouldn't have to paint it but I did for the same reason I didn't just drill it into the deck... I care way to much about my boat (Like most of you). Obviously this could work for various accessories. I have seen a similar idea used out in front, but this was very simple and worked better for my setup.

    I created a google album for ease of viewing. Here are more photos: https://photos.app.goo.gl/ZDih8ihYtsoYrpGU7
    h2-5.jpgh2-4.jpg
    I have a boat.

  2. Member CastingCall's Avatar
    Join Date
    May 2012
    Location
    MN
    Posts
    5,058
    #2
    Turned out very nice!

Tags for this Thread