Results 1 to 5 of 5
  1. 02-21-2019, 05:56 PM #1
    Jksligar
    Jksligar is offline
    Member
    Join Date
    Feb 2019
    Location
    Conroe Texas
    Posts
    3
    New to the forum! so here is my issue, red
    Last edited by Jksligar; 02-23-2019 at 05:54 PM.
    Reply With Quote Reply With Quote
  2. 316jughead
    316jughead is offline
    Member
    Join Date
    Aug 2009
    Location
    Wichita KS
    Posts
    4,917
    #2 02-22-2019, 04:43 AM
    Welcome to the forum. Still have 115 compression on that cylinder?
    Reply With Quote Reply With Quote
  3. Jksligar
    Jksligar is offline
    Member
    Join Date
    Feb 2019
    Location
    Conroe Texas
    Posts
    3
    #3 02-22-2019, 08:14 AM
    Yes sir but that was cold, Im gonna do a warm test today but was advised that exhaust adapter gasket could be causing the issue
    Reply With Quote Reply With Quote
  4. ChampioNman
    ChampioNman is offline
    SC Club Moderator ChampioNman's Avatar
    Join Date
    May 2004
    Location
    Crawfordville, FL/Lake Hartwell, SC
    Posts
    71,276
    #4 02-22-2019, 08:31 AM
    When you replaced the head gasket did you rotate the flywheel to make sure the ports on that side all cylinders lined up? Meaning did you notice if a sleeve had rotated? That has happened before, not common but it has happened.
    Reply With Quote Reply With Quote
  5. Jksligar
    Jksligar is offline
    Member
    Join Date
    Feb 2019
    Location
    Conroe Texas
    Posts
    3
    #5 02-22-2019, 10:52 AM
    I turned the flywheel to inspect cylinder. I didnt notice anything off.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »