Finally got around to doing a good detail job on her. Under the seats was nasty. 20 years for dirt, dust, and pollin.
Finally got around to doing a good detail job on her. Under the seats was nasty. 20 years for dirt, dust, and pollin.
Stroker w/ 300 SuperMag
Looks great!!1 Is that boat from Huntsville?
Nice
That’s a slick rig!
Fitzgerald Rods
Stroker w/ 300 SuperMag
Cleaned up nice!!!
Diggin the red !!
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
Very nice looking rig, congrats.
I think that one came out of the Birmingham area. It’s one of those times I was kicking myself for not having the cash laying around to grab it.
Looks great good job.
Looks great lota work, i know also
Ron Fears
Stroker/300XS
1E003823
Yeah it was good timing for sure. I just sold my house and had the cash on hand to negotiate a real good price. Still has less than 200 hours on the entire rig. The only things that were not original are the trolling motor and jackplate switch.
Stroker w/ 300 SuperMag
Man, I had to clean my shop just to get mine in to clean it LOL
Ron Fears
Stroker/300XS
1E003823
Can we trade for a while and you make mine look like that, LOL??
Stroker / 250xs
Triton 180 / 175 pro xs
Sounds good, I can make them look good if needed. I wet sand, high speed buff, polish, clean carpets ect.. I've redone a few. This one was a gem and just needed to be washed. But seriously if you want you can leave yours with me for a weekend and I can clean it up. You can call or text me 904-674-4503.
Check out this 1996 procraft I did.
Last edited by ANG; 02-28-2019 at 08:59 AM.
Stroker w/ 300 SuperMag
I can't keep mine off the water this time of year. Last week was helping with a high school tx and took two girls from Lakeland Christian. The week before was Messers, This week is Xtreme, Next week is Rodeheaver( see you there!) . Then Messers again.......No wonder my boat's ragged out. lol
Stroker / 250xs
Triton 180 / 175 pro xs
Gonna post some pictures of mine when I figure out how to and also get done with my cleaning and work I am doing to it.....
Ron Fears
Stroker/300XS
1E003823
I removed the seat adjusting rails from under driver seat, cleaned, what a mess, when I installed seat back without rails it left a inch gap behind it. I am going to take out and see if spacing the front up will get rid of the space behind. Almost there, man lota work
Ron Fears
Stroker/300XS
1E003823