-
Vessel View Mobile (Install Question)
I have searched all over the boards hoping this has been answered, but I cannot find the port to mount the unit to. I have a 2019 proXS 200hp. Do I need to remove something? None of the installation videos I have watched mention removing any plastic covers... I seem to be the only one that can not find the yellow end. Any help is appreciated. Thanks.
-
The 200, 225, and 250 proXS 4 stroke should all be the same. Anyone have pics of installs on one of these motors?
-
I just installed mine om my 2019 V6 200 and the connector was in the back. However, mine had a red cap instead of the yellow. I did double check with my dealer and he confirmed red was correct. Works great.
-
Mercury 3L/4 Stroke/Verado Moderator
Adam- If you would, please take a moment to review the Announcements at the top of the Forum, and be sure to provide the Required Info each time you post. Thanks!
Glad you found the terminating resistor- be sure to put it back on the Vessel View Mobile's harness (and route the module over to the STB side/top of the engine with the cleanest direct-line-of-sight to the console (for best connection results).
Enjoy!
-
Will do. Thanks. BTW, not able to get it to the front of the motor. The harness is not long enough. It only goes about 3/4 of the way around. I mounted it on the back... I am really am only interested in hours and codes, so even if the connection is spotty when running it should work (hopefully).