Results 1 to 4 of 4
  1. #1
    Member
    Join Date
    Jan 2019
    Location
    Bryan, Texas
    Posts
    16

    Wanted: Transom wood removal from 1985 bass boat

    First: I'm new here and I'm not sure if this is the best spot to post this. Please let me know if I should post somewhere else instead.

    I'm looking for someone to remove the wood from the transom of my boat (185 Ranger 320v) so it can be prepped for seacast. I am located in Texas and would prefer to do business there. Thanks!

  2. Member crank68's Avatar
    Join Date
    Mar 2011
    Location
    Kenly, NC
    Posts
    17,416
    #2
    Welcome !! This is the right place. You may also wanna post it in the Texas Forum. Someone may know a shop. Wish you were closer I could hook you up....
    BULLET 20 XRD/250 Merc Sport XS
    www.ncboatguy.com

  3. Member
    Join Date
    Jan 2019
    Location
    Bryan, Texas
    Posts
    16
    #3
    Ok I will post there and hope for the best...Thanks!

  4. David Cheney
    Join Date
    Sep 2007
    Location
    Texarkana, TX
    Posts
    38
    #4
    I did one for a friend 3 years ago on a skeeter. All you need is a long drill bit, 1” wide metal bar longer than the transom with a bend 4” long to scoop out wood. A wide and long chisel and hammer. A vacuum with a long nosel. Pull motor off and out of the way. hack saw the smallest amount off the top of transom where the motor is. Drill, dig, Chisel and repeat until all wood is gone. The more wood you get out the better. Sea cast is a great product.

Tags for this Thread