Like Jerry said, go with SS screws.
Like Jerry said, go with SS screws.
2008 BULLET 21XD 2007 Merc 300xs
Expansion and contraction...you'll have to fasten that or it will never stay in place
Most people stretch this trim when putting down/on. It needs to be warm and pushed into a inside curve. A outside curve will pull up or down if stretched on a angle. I'd be willing to bet if you pulled that strip up. From the loose spot to the closest end and heated it to bring back memory. When you push it in place. Your strip will be around a 1/2" short.
If the surface you're attaching 3M tape to is clean. You should have to cut it loose.
That's funny right there.Originally Posted by Walkabout7781
Kromer's suggestion of pre-cleaning the area with India Pale Ale won't help a darned bit.
I should have known Isopropyl Alchohol (IPA) and beer would get confused here
If both surfaces are clean and warm, and time is given for the adhesive to bond, 3M VHB will hold. You'll have to cut or pry it off
"Better to remain silent and be thought a fool than to speak out and remove all doubt."
drill a hole and rivet it
Reply With Quote