Yes the center shaft is adjustable up and down about 8-10 inches.
Yes the center shaft is adjustable up and down about 8-10 inches.
_The handle is a 2 piece that has a insert that extends to about 38 inches and is adjustable to any length you need.
This would work great with hydro wave also and side transducer
curious as to how far you have to reach out to use the handle when the motor is deployed? If you want to get a 360 view is it difficult to reach the handle when it's extended away from you?
It ratchets around so you can move it anywhere or keep it in front of you in other words it stays in line with your hand
watch the pointer it moves and than doesn’t that’s how you ratchet back and forth.
ultrex mount
I fish a lot of matted hydrilla and other grass. Do you think it will raise high enough to get transducer out of water in those situations?
If you fish that I would have Dave cut the outer case down about 7 inches that way you can have the scope out of the water when needed
where my finger is he can remove part of the outer casing and than you will have more travel with the scope rod
Jerry, A piece of suggestion for you: why not use a big gear wheel coupled with a small wheel? A 60 degree rotation or less on the big one can drive the small one 360 degrees. Just my 2 cents.
The reason we went with the handle and a longer handle was there’s no way to reach the wheel ,you would have to stand on bow and bend over.We have kicked a few other ideas around and even played with them but try to keep it as simple and easy to repair on the water if needed
Can you post a video of it turning 360.? I take to get a 360 turn you have to move the handle quite a few times.
Your scope has forward and rear ,really no need to go all the way around but if you need to just go half way a pull handle back .
Last edited by TOUCH OF CLASS; 02-01-2019 at 08:03 AM.
Only to look behind you when trolling.
What’s the distance between the shaft of the motor and the shaft of the pole? For some reason the head on my ultrex looks longer. Maybe not
45 inch shaft your could be 54 or 60
I meant the distance between the shaft of the trolling motor and the shaft of the transducer mounting pole.. maybe 8" ? mine is 45" as well but the head unit on my motor looked longer than yours in the pic which might not clear the handle on the mount. It's probably just an optical illusion.