Results 1 to 4 of 4
  1. 01-20-2019, 10:38 PM #1
    Hdgeorge001
    Hdgeorge001 is offline
    Member
    Join Date
    Jan 2015
    Location
    Temple,Texas
    Posts
    2

    Solix side imagining problems!!

    I did the newest update for my solix 12 and it immediately has problems on side imaging. The left side shows but the right side just shows a bunch of lines and blurs. My solix 15 was working fine and then I updated, soon as I linked them the same thing now happened to my 15. I’ve isolated them by disconnecting all networking and then restored defaults. I ran them on separate transducers but the same image appears on side image. 2D, down scan, and side scan work correctly. Anyone else have any issues after the update?
    Reply With Quote Reply With Quote
  2. chrisansilver
    chrisansilver is offline
    Member chrisansilver's Avatar
    Join Date
    Apr 2015
    Location
    Lindale Tx
    Posts
    234
    #2 01-20-2019, 11:26 PM
    I would try a reload of same. Then if no luck I would do a reset on factory defaults.
    2019 FX21 LE
    2019 Sho 250
    Humminbird Solix 15
    Humminbird Solix 12
    Humminbird Helix 12
    ML
    Ionics
    Ultrex iLink
    Reply With Quote Reply With Quote
  3. jasonG
    jasonG is offline
    Member
    Join Date
    Sep 2009
    Location
    joliet
    Posts
    4,198
    #3 01-21-2019, 04:53 AM
    Had this happen on a helix I needed to restore defaults a few times. Each time oddities in the software went away and si worked properly again
    Nitro z21
    Reply With Quote Reply With Quote
  4. bobcoy
    bobcoy is offline
    Member
    Join Date
    Apr 2008
    Location
    Lakeview,AR.
    Posts
    8,068
    #4 01-21-2019, 09:30 AM
    Have you adjusted your SI settings? Sensitivity and other setting parameters have changed and you need redo them. Did you load your saved setup from before the update? Those would need redoing for the imaging stuff.Bob
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »