I am getting ready to redo my bunks. I have measured them, but without pulling the carpet off I can’t tell if they are standard 2x6 or if they are contoured.
Anybody know?
I am getting ready to redo my bunks. I have measured them, but without pulling the carpet off I can’t tell if they are standard 2x6 or if they are contoured.
Anybody know?
2006 Triton TR196 w/ 200 Optimax \ 2021 AlumaRyder 1860 w/ 200 Rotax
I used treated 2x6's from Home Depot and rounded the edges off with a 1/4" router bit.
I am planning to put Gatorbaks on. Would you still round the edges?
2006 Triton TR196 w/ 200 Optimax \ 2021 AlumaRyder 1860 w/ 200 Rotax
Good question. Best to contact the Gatorbak guys directly. Seems to be a great product that is well supported.
On my 2007 the factory bunks were not rounded. IMHO not really worth it. Might do just the insides where the keel makes contact to center up. “Leading edge” tapering is pretty pointless to me as my boat never makes contact there ever anyway. My first contact is at least 1/3 way up the bunk but some of you guys may see much shallower cut ramps than where I launch.
I sell and install Gatorbacks...don’t round the edges...
BULLET 20 XRD/250 Merc Sport XS
www.ncboatguy.com
^——this