Have installed this graph on my Ranger 178C aluminum boat. My problem is in the placement of the transducer. After the boat reaches ten+ mph, I loose bottom. I readjusted the transducer to be level when moving but I now loose bottom at 15 to 20 mph. Would placing the transducer lower in the water help with this issue?
Lower probably won't help cause it will be "plowing" thru the water....it needs to be "skimming" on top and still have contact with water....
Can you post pics of the location?
YOU are not entitled to what I have earned!!!!!
2014 Phoenix 619 Pro / 2014 Mercury 200 Pro XS
I will try to take a picture or two when the weather permits. thenks for the reply.
Last edited by J.Mac; 12-07-2018 at 06:31 PM. Reason: adding photo
Get them from all angles the best you can.....
YOU are not entitled to what I have earned!!!!!
I have taken several pictures but can not get them to posted on the message board.
Probably too large. Resize them and you should be set.Originally Posted by J.Mac
2024 Phoenix 818, Mercury 175 (3B414035) Trick Steps, 3 Garmin 106 SV,s, LVS 34. BoatEFX dual bow mount. Ionic 12V 125AH, 2 12V 100 ah LiTime’s for the TM. Minn Kota 345 PCL charger,
Send them to me: jnsonnier31@gmail.com
YOU are not entitled to what I have earned!!!!!
Have resized them for the message board, but they will not post.
Looking at your pics and in my opinion, the best i can tell is that you have the ducer to close to the strake on bottom of boat. I think that if you can swap places with the speedo tube and put it bottom of ducer just below bottom of pad that would give you a starting point.
Last edited by fishin couillon; 12-09-2018 at 02:00 PM.
YOU are not entitled to what I have earned!!!!!
Reply With Quote
