Ok I'm a dummy, get that out of the way. 1983 mercury 150 SER. # 6431959.
Ok so I pulled the powerhead to replace the gasket (s) associated with and the base plate. All that went fairly easy. Didn't pay attention when I disconnected the likage, didn't think to take picture with my phone either. The cable that slides in the bracket, there's two springs, one stays on the stud the other goes where? Doing this on my tablet and not sure how to upload a picture as my lap top to a dump.
Does any one have an exploded diagram of this? I've tried to google it and can't find mine, two cables the top cable to throttle arm (?) Is straight forward.
Again yes I made a dumb move diconnecting all of it instead of just the cable to arm and three bolts that hold the bracket to the power head.
Ser # 6431959.
Thanks in advance.