Results 1 to 3 of 3
  1. 11-18-2018, 07:51 PM #1
    Travis
    Travis is offline
    Member
    Join Date
    Mar 2005
    Location
    Elko Ga
    Posts
    716

    Question Little set up help with efi

    In need of some help with a 2100 bumble bee and nothing going anymore in their forums. Having a hard time with bow lift on this boat. 01 super vee with 03 225 efi 25 torrent. Running about 3 inches under pad. 68/69 completely empty and one person only making 5600 at wot. Ran today after getting prop back from Mark. Bow lift still bad but hole shot and mid-range is awesome. Question is with this boat and motor is that the best top end I'll get with this setup and can I raise the motor to get the desired rpms I need (5800) and not lose what little bow lift I have? Water pressure is 25. Thanks in advance.
    Reply With Quote Reply With Quote
  2. WVBullet
    WVBullet is offline
    Member WVBullet's Avatar
    Join Date
    Oct 2015
    Location
    Gallipolis Ferry, West Virginia
    Posts
    15,036
    #2 11-18-2018, 07:58 PM
    For a TM type lower that sounds about 2” too low.

    2008 BULLET 21XD 2007 Merc 300xs

    Reply With Quote Reply With Quote
  3. Bullet Bling
    Bullet Bling is offline
    Member Bullet Bling's Avatar
    Join Date
    Nov 2007
    Location
    Kettering Ohio land of small fish
    Posts
    1,831
    #3 11-19-2018, 05:03 AM
    I have no experience with that boat. I would think with that water pressure and rpm u could move it up some keep the pressure between 12-15 psi.
    2005 Stroker 2010-250pro xs
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »