I replaced my 24 volt motorguide with a 112 Ultrex 36 volt What size wire is recommended to supply 36 volt for about 21ft?
I am going to rewire from the batteries up to the Ultrex ?
I replaced my 24 volt motorguide with a 112 Ultrex 36 volt What size wire is recommended to supply 36 volt for about 21ft?
I am going to rewire from the batteries up to the Ultrex ?
I would use 6ga. Could probably get by with 8 on a 112, but I think 6ga is a better choice.
John
BBC Sponsor since 2006: (870) 773-3474
Mon - Thrs 8am - 5pm Central
Friday 8am-12pm
Garmin Certified Dealer and Installers: Call us for all your Garmin Electronics needs!
ASC for: Garmin, Lowrance, Minnkota, Humminbird, and Powerpole.
[SIGPIC] http://www.jonestrollingmotor.com
[/SIGPIC]
and use a 60 amp circuit breaker in + line close to battery
If the batteries are adjacent only one breaker is needed since the same current goes through all 3 so it only needs breaking in one place.
However if the batteries are separated by some distance where the interconnecting cables could be exposed to damage then a breaker on each battery may be justified.
BCB puts breakers on the jumpers at the factory. I removed mine seeing as they are not necessary and are only another source for potential electrical failure
2019 BCB Classic
Merc V8 200 4S