Question on existing breaker in 2008 200 XL

[Rubber_Duck]

Hello,

I picked up a 2008 200 XL late this summer and am planning to upgrade the trolling motor soon. It currently has an 24V 80# maxxum which I want to replace with a 36V ulterx. My question is if anyone know what size breaker this is in my boat. I have attached a picture of said breaker. Going by the manual on a new maxxum, it should be a 60 amp breaker, but I can't tell for sure. I'm ordering some electrical parts for other new electronics, so I was wondering if I needed to order a breaker to replace this one. Thanks!

[Javelin389]

Based on the TM you currently have, it's probably a 40A breaker. I would replace it when you install the new TM.

[Jim R]

I replaced mine when I upgraded from 24V to 36v. Same boat.

[Rubber_Duck]

Thanks guys!