Thread: SAC testing

Results 1 to 3 of 3
  1. #1
    Member
    Join Date
    Jul 2016
    Location
    Warren, NH
    Posts
    462

    SAC testing

    I have an 04 225H.O. Model # E225FHLSOB that I am having problems with the cold start. I am not getting power to either side, I or S of the starter solenoid and no power at the relay. I even checked the ground at the relay and nothing but I think that is controlled through the EMM from what I have read. All the fuses on the motor are good. The manual is not a lot of help in this with for how it jumps around so much. I am going to try and print the wiring diagram tomorrow to see if I can chase wires and see if that tells me anything.
    2004 Ranger 521VX with 2019 Evinrude G2 250 H.O.

  2. Member
    Join Date
    Jun 2016
    Location
    Houston, TX
    Posts
    360
    #2
    It is unclear what your issue is, will the engine not crank or not start?

    I properly sized battery with a good connection is critical. No wing nuts and no more then 4 terminals per battery post.

    Also I usually plug a known good key switch directly into the engine to bypass all the stuff in the boat as possible issues.

  3. Member
    Join Date
    Jul 2016
    Location
    Warren, NH
    Posts
    462
    #3
    Motor starts just fine. It won't go to it's high idle for warm up. I have to manualy throttle up for warm up.
    2004 Ranger 521VX with 2019 Evinrude G2 250 H.O.