Thread: camper furance

Results 1 to 7 of 7
  1. #1
    Member
    Join Date
    Jun 2004
    Location
    ft.jennings,ohio
    Posts
    853

    camper furance

    I ran out of propane some time in the night, got up in the morning and changed tanks. Now my furnace won't light. It had been running just fine until I changed tanks. The stove and water heater works fine so I know I have propane. The furnace has a 3 blinking light code which says it's a ignition lock out fault. Anybody know how to reset the code or know what may be the problem. Thanks Rick

  2. Electrical/Wiring/Trolling Motors Moderator CatFan's Avatar
    Join Date
    Jun 2004
    Location
    SW Indiana
    Posts
    26,089
    #2
    Normally cycling power will clear the fault and let it light.
    If you have integrity, nothing else matters. If you don't have integrity,
    nothing else matters.​

  3. Member
    Join Date
    Jun 2004
    Location
    ft.jennings,ohio
    Posts
    853
    #3
    I have been cycling thur the thermostat all morning, still not lighting

  4. Electrical/Wiring/Trolling Motors Moderator CatFan's Avatar
    Join Date
    Jun 2004
    Location
    SW Indiana
    Posts
    26,089
    #4
    Quote Originally Posted by ViperBass View Post
    I have been cycling thur the thermostat all morning, still not lighting
    Shut off power with the battery disconnect switch. You need to remove power from the furnace.
    If you have integrity, nothing else matters. If you don't have integrity,
    nothing else matters.​

  5. Member
    Join Date
    Jun 2004
    Location
    ft.jennings,ohio
    Posts
    853
    #5
    I shut the power off to the furnace 4 times, still not lighting

  6. Electrical/Wiring/Trolling Motors Moderator CatFan's Avatar
    Join Date
    Jun 2004
    Location
    SW Indiana
    Posts
    26,089
    #6
    Check for a blown fuse. Might be one in the panel or on the control board
    If you have integrity, nothing else matters. If you don't have integrity,
    nothing else matters.​

  7. Member
    Join Date
    Jun 2004
    Location
    ft.jennings,ohio
    Posts
    853
    #7
    Got it going, just had to cycle it a couple more times. THANK YOU!!!!!!! Rick