Looking for experience or thoughts about epoxying the speaker to inside of fiberglass boat hull.
I know some people have done it.
Looking for experience or thoughts about epoxying the speaker to inside of fiberglass boat hull.
I know some people have done it.
I wouldn't do it. When the speaker goes out its gona be a pain to get out. Iv had to remove a transducer once... what a pain. Thats just my opinion
Yes sir I've had a dose of epoxied puck removal in a tight place myself.
If the speaker goes out I won't be concerned about tearing it up to remove..
I want to get it off my trolling motor and I've heard they can be mounted in the hull and it will help with sound transmission. Would like to hear some reports but it does not look like many have done this.
I don't think it would be loud enough. Works much better in the water than in the boat. JMHO
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
better in the water, so it can move the water, the hull will only let noise through. transom mount would work for me if i had to much going on on the TM
Mercury 250 proxs 2B115089
Why do you want to move it inside the boat?
Pat Leach
USAF MSgt Retired
1992 Procraft 180 Pro
2016 Mercury 150 Four Stroke
2018 Minn Kota Ulterra
Helix 7 SI/GPS
Helix 7 Sonar/GPS
Last edited by fishnfireman; 10-18-2018 at 04:54 PM.