Portable Livescope Build DIY

[MatfromWisco]

Here is a complete video on how to build a DIY Livescope Portable Bundle for ice fishing or for the mobile fisherman! Under 20lbs and enough battery to make it 11+hours on 100% screen brightness and almost 15 hours on 50% screen brightness!!!

Parts required
010-01901-01 93SV Plus with CV-52 Transducer
010-01864-00 Livescope System
010-12676-00 Large Portable Ice Kit
010-12676-10 Ice Fishing Pole Mount
010-11425-04 Right Angle LS Power Cord
010-12445-00 Echomap Plus Power Cord
010-12673-03 Extra Bail Mount if going on a boat or kayak
10 ah 12 Volt Lithium Battery Needs Two!
151mm×95mm×65mm each
151mm×95mm×130mm when stacked on side!
Lithium battery charger 3 amps atleast
Female spade terminals, heat shrink, butt connectors
You will have to assemble the DIY cord to run both batteries in parallel and also add a charging port. Pretty much all power to one connection and all grounds to another. Fuse holders at each positive battery connection.

Those of you that use facebook plz join Garmin Panoptix Ice Fishing Group tons of neat up north uses!

[canon]

nice

[kojimep]

Have you found a good container for holding the large garmin setup? It'd be nice to have something to give a little extra protection when traveling, and it is also nice to be able to have the unit off the ground for easier viewing, but I cannot find a bucket or decent container that would be large enough to hold it without being excessively over the size needed?