Added a HDI ducer to my Triton for an HDS 7 gen 3...need to raise the bracket up a little. What do you guys use to seal the old holes?
Added a HDI ducer to my Triton for an HDS 7 gen 3...need to raise the bracket up a little. What do you guys use to seal the old holes?
3M 5200 sealant
I also used 3M sealant to cover up one of the holes I didn't use when mounting my phenolic plate in back. I bought a plate from Cabela's to hang everything back there from. It's worked great so far. If I run out of space to drill holes I'll simply replace it with a new one using the original holes. I used 4200 because it may have to be removed. Either one should do what you want.
JB Marine Weld epoxy. But you’ll have to sand it down and touch up paint. But it’s permanent .
Have an adventure everyday !
2006 PT 175 TX 60 HP.
Thanks guys..Ill pick up some 5200.
3M5200. The boater's friend for decades.
Use the existing holes to mount some starboard and then mount your new transducer to the starboard/seaboard.
2016 Ranger RT188, Yamaha 115 sho, dual console, 80# Ultrex, hotfoot, networked HB Solix 10 & Helix 9, Mega 360. Powertech NRS3 18p, Atlas 4" jack plate.
Use same hole and buy a cutting board from walmart, or restaurant supply. Set ducer on it and make small adjustments