Hey guys, having issues with my Ultrex. I bought it in July, installed and fished five days. Next time out (two weeks later) the button didnt work. Everything worked normal with the remote. I removed the motor and took it to an ASC and the tech couldnt find a problem. Installed the motor back on and it worked for one trip. Now, I am having the same issues. I tried moving the switch in the pedal up and down with no luck. If I push it up too high the remote will not work. One other thing is that the battery indicator on the remote has an exclamation point on it as if the batteries are low. Batteries are fully charged. I pulled the pedal and removed the plate to see if something was pinched but everything looks ok. I had 24V to the wires coming from the plug to the spade terminals. If I push the switch the other wires get nothing, if the remote is turned on the other wire gets variable voltage depending on what the speed is set at. Long story short, it appears that either the switch or the board that its wired to may be bad. All functions with the remote work normally, speed, spot lock, steering etc. The thing throwing me off is how if the switch is pushed all the way up it stops remote function leading me to believe that the switch has to be working. Is there anything else I should mention to the ASC? I would imagine that if the two wires on the switch were jumped and it worked that would confirm a bad switch but to do so would require cutting the wires.