Hello,
Motor is a 1992 Johnson 120 V4, Model J120TLAND, S/n G03002936.
Here is my problem.
Motor will only run for 5 seconds. It is running on choke injection. This is some type of fuel delivery problem.
If I spray gas/oil mix into carb intakes it fires right up until gas is gone
Here is what I have done.
Disconnected VRO and runnning on 50/1 premix
Replaced stator as power coil tested bad.
Replaced trigger while top of motor was exposed.
Cleaned carbs. All four carb inlet nipples were plugged with something I never was able to see. Ran carb cleaner through them until I could blow air freely through.
Went through the throttle plate sync according to Johnson factory manual.
Previous owner replaced powerpack one year ago.
Can the Joe Reeves timing method be used on this motor?
What do I do next?
Thanks
rcb130