got a 999 si hd about 2 years old wont shut down have to take the power plug out. Then when you put back in turns on automatically. Just did down load on it to see if that would help
the first one that i have done didn't help
got a 999 si hd about 2 years old wont shut down have to take the power plug out. Then when you put back in turns on automatically. Just did down load on it to see if that would help
the first one that i have done didn't help
Check to see if the front cover has been misaligned causing the button to stick.
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
looks good push in button feels like the rest of them firm
Wayne Purdum
Charlottesville, Va.
Helix 12 CHIRP MEGA+ SI G3N/G4N, Helix 15 CHIRP MEGA SI+ GPS G4N
SOLIX 12 SI/G3, Helix 8 CHIRP MEGA SI+ G4N, Ultrex 80/LINK, MEGA360,
MEGA LIVE, LIVE TL
is there a way to realign
You might be able to pop the front bezel off using a dime - there are slots along top and bottom edges - and you must make positive you re-seat the card door seal exactly as it was (small ridge into main case) when reattaching the bezel.
Be very observant of the parts alignment and don't blame me if anything goes awry - I've known how to do this for about a decade and doesn't apply to Helix or Onix/Solix only the number series.
If the face plate doesn't do it - the internals may be misaligned or there are deeper problems, in which case you might be best off to have HB service the unit (unless you have electronics experience and take matters into your own hands).
BE ADVISED, there have been cases where HB has replaced those with a Helix model due to manufacturing age - so if the fee is high and you get a newer machine, I don't consider that a bad thing but it's not a guarantee.
Robert
Newaygo CTY, MI
Helix12MSI G2N v1.84/Helix10MSI G2N v1.84/Helix10MDI G2N v1.84/ASGPSHSx2/iPilotLinkv2.15/2.04RC-1+2/