360 imaging - transom or bow mount?

[Fred H]

The 360 comes with a 20' Ethernet cable, 6' power cord, and a AS GPS HS antenna.

There is no mount for a Terrova, so that leaves you with the choice of the 360 transom model unless you want to invent or purchase a third party apparatus to use the bow model at the bow.

If you are using LINK, you have the AS EC QDE Ethernet adapter to the unit connection, so you would need the AS ETH 5PXG Ethernet Switch to have the three Ethernet connections.
The display, LINK, and 360 would connect to the Ethernet Switch.

Thank you, Wayne. I need a power switch to turn the 360 on when deployed and off when retracted, correct?

[Wayne P.]

Thank you, Wayne. I need a power switch to turn the 360 on when deployed and off when retracted, correct?

Yes a disconnect switch to turn it off when not using it.
Need one for the AS ETH 5PXG also.

[Fred H]

Yes a disconnect switch to turn it off when not using it.
Need one for the AS ETH 5PXG also.

Disconnect power to the 360 when retracted for using outboard to relocate?

[Wayne P.]

Disconnect power to the 360 when retracted for using outboard to relocate?

Not necessary.

[Fred H]

Not necessary.

Good, that makes my wiring job, and operating the 360, easier. Thanks Wayne.

[Wayne P.]

Good, that makes my wiring job, and operating the 360, easier. Thanks Wayne.

When you get it, pay attention to page 41 of the manual for transporting on and off the water:

https://humminbird.johnsonoutdoors.c...SI_532050E.pdf

[tweakjr]

Disconnect power to the 360 when retracted for using outboard to relocate?

It should stay powered on until you put the cover back on.
If left uncovered with power off, it can creep out of the stowed position unknowingly.