Stoltz Bow Rollers

[DREWTICK]

Guys Im stocking Stoltz Bow rollers for all boats and can mix and match to suit you needs, if you need assistance I will be happy to help
get them here: http://www.drew-tek.com/parts/produc...y/bow-rollers/

[HawgSnatchin]

Rigged these up on my 2017 Z-20 and incredible what a difference it makes. Stock rollers are junk and this is well worth the investment IMO

[BigBadBass]

Got any for a nitro z21?

[jasonG]

I need to order for a z21

[DREWTICK]

I have these for every application, I just dont have the specs for all boats but I am working on a data base using photos,
when ordering a replacement bow roller be sure to measure the length across the center roller, just the center, not the brackets or the length including end caps, then measure the outer diameter of the end caps, and verify the bolt size, most common is 1/2" but some have a 5/8", if you are not sure or maybe you are looking for a better fit, take a picture from the front to send me,
pm me and I will give you the number to text pictures to and I can match you up or suggest something better

[jtrac]

I put a set on mine and they are much better than the originals. I was getting some marring but that stopped with the Stoltz rollers.

[jasonG]

Sorry for bringing back a old thread but what model did you guys use for a nitro? I need to replace myz21 roller. I know I need a 3” but not seeing anything the matches as far as the end caps. Worried the angled end caps would not work that are offered on the ult3 series

[crank68]

Order with confidence !! Got my new one from DRETICK and transaction went flawlessly !!

[jasonG]

Order with confidence !! Got my new one from DRETICK and transaction went flawlessly !!

Thanks i I did early winter but what I got doesn’t work as far as the end caps their a little to small and the bell ends I also got just seem to extreme for the bow. Maybe I’m overthinking and it don’t really matter. Drewtick pieced together a assembly

I asked before on Facebook owners page and got no info other than to order stoltz. No model info or pictures

[zeke4351]

Anything for sure figured out on a Nitro Z21 yet?

[jasonG]

No info at all

[DREWTICK]

we are on test number 3, guys a I have some guys with Z21s trying some roller combos that I worked on myself, if it works out I will see if they will make me a batch.
I have one now that will work and is very close but trying to improve on the fit.

I should have pictures back in a couple of days,

[zeke4351]

Thanks for the update.

[DREWTICK]

Z21 update here is where we are at, I will have to cut these to size by hand, if it looks like enough people are interested I can get Stoltz to make them but I will have to buy a bunch.
pm be if you want to get one.
IMG_1982.jpg

[DREWTICK]

also I could use some more pics of the factory setup, and a verification on width between the brackets.

you can also email andy@drew-tek.com

[jasonG]

It’s 3” between the brackets. The caps are round not beveled and are about 3.5” od

your picture looks spot on if measurements are close

[TXZ21]

PM sent about ordering for my Z21 when you have product available. Thank you.

[TXZ21]

Order placed on your site.

[bison2312]

TXz21 let us know how it goes, would like a set myself

[TXZ21]

Finally had time to install the new roller today. The Stoltz roller DREWTICK sold me fits like a glove, and works great! Here are the before and after pics: