-
20i glove box
A little late but I am doing some spring cleaning... Anyone know how tighten up the screws on the glove box hinge on passenger side(dual console)?
07 20i
Last edited by W.O.T; 08-20-2018 at 06:33 PM.
-
I haven't had the issue of it becoming loose yet but I would bet when it needs to get tightened, I will remove the screws and put in small bolts w/ lock washers to snug it back up
-
I would like to do that, but I cant seem to figure out a safe way to get to the nut side of the hinge. I am referring to where the glove box itself connects with the hinge
-
Can you unscrew the rear wall of the rod compartment and access it through there? Seems like there was an angle bracket holding up the wall and it had a screw to the wall and one to the floor.
-
I don't think you can access through the rod locker as it sits far lower than the console
-
it looks like I have to take the whole console apart to get at the other end of the screws
-
I thought you meant single console. I must have misunderstood. We are talking about 2 different things if you have the passenger console. The passenger glovebox on a single console is still up under the console on a dual. You just don't have the door but still have the cubby hole. Its directly on top of where the passenger footrest is.
If you're talking about the glovebox door on a dual console I'm way off.
Last edited by K.D.; 08-20-2018 at 05:23 PM.
-
Thx Basstrix!!! He helped me unlock the mystery.
-
Thx Basstrix!!! He helped me unlock the mystery.
-
sooooooo
unlock it for the rest of us please
-
1. remove screws in windshield
2. remove 2 locknut/bolts that attach the grabhandle
3. remove 2 screws just above the hinge that hold the glove box molding
4. pull it out...