1997 Merc XR6 150 hp

[mibus2]

In need of advise/help and yes I am female and not a mechanic but hubby is not one to get online outside of looking up parts or stuff on Craigslist.

We purchased a used 1997 Astro with 97 Merc XR6 150 hp
got it home and hubby who is retired mechanic started going over things and found the lower unit has issues.

He has the mercury manual we purchased to help some but he is not versed in Mercury boat motors.
Basically he is telling me the lower unit needs to be replaced.
That means we're looking at roughly a thousand to replace with a new lower unit.
(yes as we all learn BOAT = Break Out Another Thousand)

He found a 99 lower unit it says the shaft is 25", but we are wondering when measuring the shaft where are you measuring to and from?
for ours if you measure from the top of the water pump it is 21" but is that the correct place to go from?
if so then that means the one he found won't work of course.


any advise or help is greatly appreciated

[Lowerider58]

I believe the way the midsection is measured is from the point that it meets the power head to the joint where it meets the lower unit. Most bass boats have the shorter 20" midsection.
Post the serial number of your motor and someone will be able to look it up and see exactly what your motor is.

[mibus2]

the serial number is OG487657

[SilverFox579]

Might try reposting in this forum, your engine falls in the displacements covered there (not just high performance) - Mercury - 2.0/ 2.4/ 2.5 Liter High Performance

[mibus2]

THANK YOU I will go do that right now