1999 Evinrude Ficht 225hp - Setting TPS to Spec w/Diagnostic Software

[stratos]

1999 Evinrude Ficht 225hp
Model# E225FPLEEO

Throttle Position Sensor & Cap Assembly 5000807

I’m in the process of replacing what I think is a faulty Throttle Position Sensor (part #5000807) on my 1999 Evinrude.

I have the service manual and the diagnostic software.

Using the software can someone tell me what the procedure is to set the new TPS to Specs?
I couldn’t find anything on this and I’m not sure if I have the manual for the software. What I found showed how to set the ETEC engines to Spec but nothing for my engine.

Thanks

[stratos]

Anyone point me in the right direction? I still can't find anything on this.

thanks

[SEAHORSE]

What moves your TPS? Is it a solid metal rod or a loop of wire?

[stratos]

Solid Metal Rod.

[stratos]

I was hoping to change out the TPS over the weekend. Does anyone know if the new TPS has to be calibrated?

This was the only information I could find and it says it's for the ETEC engines only. When I connect to the laptop I don't see any options to set the TPS.

[Danrude]

The manual does not show a procedure for calibrating the TPS.

[stratos]

Thanks Dan. Does that mean I can just swap it out and it should be good to go?

[Bassmeister]

The slots allow you to adjust the tps. There is a parameter from 0 at idle and the upper limit.....

[SEAHORSE]

You want the TPS voltage to be about 0.5 volts at idle

[joecol]

You want the TPS voltage to be about 0.5 volts at idle

Seahorse is there a max voltage limit at WOT or it is what it is ? I have diagnostic tool

[mactlman]

Seahorse is there a max voltage limit at WOT or it is what it is ? I have diagnostic tool

it is what it is usually. adj it at idle and what the max is will work. looks like a gm tps sensor replaced hundreds of them in the day.!!