As some of you know i have been troubleshooting my "trim fault" message that I am getting on my merc monitor. I have checked all the connections and they seem to be good. I have attached some pictures of my digital trim sending unit. The first pic is of my digital trim sending unit attached to my motor. The second picture is of the sending unit removed. The slotted piece in the middle moves freely and has stop limits in both direction with 180 degree plus rotation. The third picture with the red arrow shows the "male" tab that goes into the slotted piece in pic #2. Shouldn't that "male" piece rotate when i trim the motor up and down? I trimmed the motor up and down and that "male" piece does not move. It remains in that horizontal position the entire time. Could that be my problem?
Thank you for any advice