Dual Dash Mount for new Phoenix Dual Dash Shroud

[amac]

What dual mount are y'all using with the new Phoenix Dual Dash Shroud?

[sdendy]

I have Precision Sonar and I like them.

[DREWTICK]

scroll down on this link you will see multiple brands mounted on this mount. this is a rock solid mount for any brand or size units on the dual dash

https://precisionsonar.com/product-photos/smartbracket-phoenix/

[DEFMP]

It's not necessary to have an additional mount with the Phoenix dual dash mount. The weight of two graphs, especially 12" graphs, are heavy, and even the PS mount will not help support the poor shroud design Phoenix has. The weight on the screws used to screw into the console can for them to loosen up or even strip. This was my experience. Just be sure you check the screws after fishing rougher water.

[haus9393]

The dual dash is nice but personally I don’t think that can hold up with the abuse I would put it through. 3” guage dash with a bbt Mount for me.

[DEFMP]

The dual dash is nice but personally I don’t think that can hold up with the abuse I would put it through. 3” guage dash with a bbt Mount for me.

Yes, Champlain would be hazardous to that thing

[DREWTICK]

I have been running the Precision mount on a dual dash setup with 2 12" Lowrance units for 2 years now with zero issues, the mount reinforces the dash and makes it much stronger, as for the screws where the console mounts they can get easily striped out from over tightening and from very rough conditions on the water, I highly recommend that on any style dash or mount that while the dash is off to add some reinforcement behind the screws as many of us has done and it will be there to stay.

[GEEBASS2000]

wow that is a awesome idea!!! What is the reinforcement made out of ? What holds it in place when you screw in to it?

[DREWTICK]

wow that is a awesome idea!!! What is the reinforcement made out of ? What holds it in place when you screw in to it?

its Kydex or Starboard, I used epoxy and ran screws overnight while it set,

[Walleye1875]

Where can we buy the material Andy?

[DREWTICK]

Where can we buy the material Andy?

this will work https://www.ebay.com/itm/BLACK-OR-WH....Xstarboa.TRS0

I get a lot from amazon but it comes it bigger pieces, I like using the 1/2 thick stuff but you have to heat it to make it bend, the 1/4" will bend on its own

[Walleye1875]

Thanks Sir

[sdendy]

I did similar to Andy but I got a cutting board from Walmart and cut into pcs and exported them in.

[amac]

I’ll probably just stick with the 3 or 5” shroud. I’ve had both and never any issues. New boat is on order so I was curious about the dual shroud. I’m not too crazy about the look of the dual shroud anyways. Thanks for the replies.

[Meleagris1]

I run a dual dash lower gauge shroud but I’ve reinforced the holes with cutting board material as mentioned. Also running a single 15” Solix which is a little lighter than two 10’s or 12’s. Burned 60 gallons of gas this weekend on Champlain and all is still tight. If I suspect any issues I will add a couple more dash screws also.

[BullMerc250]

Bass Boat Technologies makes a mount for the dual dash shroud. It is not on their website yet but I can assure you it is the most stable mount on the market and can take any abuse you can give it.