Results 1 to 4 of 4
  1. #1
    Member Razorbass P3's Avatar
    Join Date
    Jun 2006
    Location
    Bentonville
    Posts
    3,916

    Trim Switch on the motor 200 EFI

    1998 200 EFI. I have full use of trim at the console and the bow. Switch on the motor has no function up or down. Discovered yesterday when loading he boat and tried to put to transom saver on.

    Ideas? Thanks in advance.
    First member of Kawasaki Outboard Prostaff

  2. Member Bass AHolic's Avatar
    Join Date
    Mar 2014
    Location
    NW GA
    Posts
    7,757
    #2
    Reolace that particular trim switch .. It's bad.. I had motor switch go up but not down, and wires etc.. never messed with but just occasional use. other switches worked fine. I took it apart, before old was trashed and was corroded switch. reckon the lake water over time caused it.

  3. Member luvdmymerc's Avatar
    Join Date
    Nov 2005
    Location
    Springfield, Missouri
    Posts
    4,160
    #3
    Bad switch or a wire popped loose somewhere. Take the top bucket off and take a look. Should be easy enough to track down which one it is.....

  4. Member
    Join Date
    Nov 2008
    Location
    Raleigh NC / Falls Lake
    Posts
    11,210
    #4
    Like said above bad switch are wire pop loose ? Mind did that last year , at first it would start trim on it on then . Just went dead .