-
What hub do I need
I have a 2003 ox66 200 (ZX200TLRB) motor. I want to put a Fury prop in it. What hub kit do i need for that prop to run on my Yamaha.
-
Hub kit number 835271Q2 or 835271K2
-
Thank you! But Does that mean either will work or you’re not sure which one?
-
Moderator
-
You clearly know a lot about props. I’m looking to run a 14x24 Fury. I had a 14.5 x 25 M on it. I wreck my lower unit I’m looking to possibly run this prop for a couple weeks as it was a buddies spare. What should I expect? I know i was told to watch my RPM’s, anything else? The boat is slow or a 2003 TR-20 with a 200 OX 66. Only goes about 61 with 2 guys fully loaded. Turns about 5300ish I think I’m not positive
-
Moderator
No reason to watch rpms if your tach is correct. You may want to lower the jackplate 1/2 as the fury runs best deeper. That depends where the motor height is now. Your rev limiter is 6150 rpms... You should really set the boat up to run 5800 wide open trimmed out.
-
I don’t have to run the spacer right?
-
Moderator
I don't know what you mean...