Anyone have any pictures or information on where is a good place to install the new measuring board holder in a 2006 Z20? I'm thinking about putting it in the little void area between the starboard rod locker and driver side console. Any suggestions?
Last edited by fish80; 06-27-2018 at 02:36 PM.
Interested
When I had that boat, I put mine inside the port livewell mounted on the divider angling out towards the front slightly.
2017 Ranger Z520c "Blackout Edition"
2017 Mercury Optimax ProXS 250
HB Solix 12 G3 MSI+, Solix 12 G2 MSI+, Solix G2 MDI+, Solix 12 2d/gps, Ultrex Mega360, Mega Live
NRA Life Member
-Be sober, be vigilant; because your adversary the devil, as a roaring lion, walketh about, seeking whom he may devour-
I had mine mounted on my Z20 under the center compartment lid. Not as easy to get to as the mounting on my Z520.
2015 Ranger Z520C Yamaha 250
Mounted mine under the port rod locker lid. Open it about 6" and pull it out.
Right now it's mounted under the center locker lid but I wanted to move it for to make access easier. I've attached some pictures to show where I'm thinking. My worry is it's not deep enough. Any thoughts?
I have everything but never cut the hole and was looking at the same spot. Anyone tried this?
Mine stays under the center lid. I'll leave it out if a dink fest starts.
Bump
I thought the center box lid was a pretty good spot in my Z21.
PThe center lid works, but I just hate having to put a fish down to open both latches and get the board out. Just trying to find a place where I could mount the new holder on the outside somewhere to save on time and just make it easier. Thanks for the input though so far.
The holder on my Z19 is on the starboard rod locker lid. I usually slide it in the net holder hole between the seats. That puts it out of the way and easily accessible.
2007 Ranger Z19 - 225 Pro XS
Reply With Quote