Is there a difference between a RakerII and a Raker II HO prop other then the vent hole adjustment? I have the vent hole adjusters out of the Raker II HO and it seems to come out of the hole slower then the Raker II that I had The only difference that I can see is the vent holes are smaller on the RakerII HO with the adjusters out then the vent holes on the Raker II
Same prop different ventilation system
Well I guess I need to get out the Drill then the vent holes aren't big enough
send it to mark and have pvs holes drilled in it. that way you can adjust with plugs??
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
Prop to pad height also plays a small part in hole shoot. If you're too deep it can hurt hole shot...the HO prop has adjustable vents. I assume you have them open all the way.
What boat and motor do you have? We could possibly offer better advice if we knew this.
John Clark — Findlay, Ohio
took the words right out of my finger tips.Originally Posted by mactlman
201Stratos 2009 250 E-tec 14 1/2 x 24 Raker II HO 10" Jack plate I have the vent holes open all the way The motor is raised up It's around 2"below pad I guess I can open the holes more with a drill
i have 8 pvs holes in my bravo and run 6 wide open and the other 2 with med openings to find the right amount of venting. so you might need slightly more?
2022 z519 cup 225 merc 4s ser # 3B210484. 2--hds12 live units. 2 poles, atlas plate, ghost, hamby's, active target, merc digital gauges
2002 basscat pantera 3 (dad bought new) sold 8-2-22
2000 stratos 20 ss (bought new) 200 hp Rude ficht great boat/motor sold 11-21
pulled by a 2500HD Denali
proud dad of an ARMY Captain
MAGA
ASE/GM Master tech before tools
Reply With Quote
