number for t/m ducer

[tav]

can't find the number on the wires .......helix 7 ,gps , sonar .
looking for a ducer for the front t/m. need to replace it.....thx

[Jonestrollingmotor]

Are you talking about an external transducer or the built in transducer on your Ultrex?

[tav]

no ......the t/m ducer that raps around the t/m. took awhile but i
found the number xnt 9 20 t. alls it shows that its for a transom
ducer .......how do you convert that to a bow ducer?
don't see any pipe clamp set ups.

[Jonestrollingmotor]

no ......the t/m ducer that raps around the t/m. took awhile but i
found the number xnt 9 20 t. alls it shows that its for a transom
ducer .......how do you convert that to a bow ducer?
don't see any pipe clamp set ups.

That is the same transducer as the US2 in the trolling motor. Why not get the adapter and use the US2? Otherwise, instead of the xnt you need the xtm

[tav]

ok....i really don't know to much about that ........i do have cable stuffed inside that i don't use.
what other cable adapt do i need to use the us2 ducer.

update....i found the us2 wire connectors but it come a variety of sizes.
do they make a single us2 cable for a helix 7?

[Jonestrollingmotor]

You need the adapter, US2 8, to connect to the US2 cable and the depthfinder

[tav]

yup....this will work....ty . how long do they make these adapters? i'm thinking about 2 ft possibly.

[Jonestrollingmotor]

yup....this will work....ty . how long do they make these adapters? i'm thinking about 2 ft possibly.

These adapters measure about a foot. You should have a 10' extension cable that came with the trolling motor to go from the head to the depthfinder.

[tav]

I did find the wire adapter, yea pretty long.
I just have to take the covers off to feed the pig tail
Thru the hole..
Thx mr. Jones.....I'm gonna try this.

[Jonestrollingmotor]

Just a word of advice, when you come out of the head with the extension, wrap around the coil cord (follow the coil cord) til you get to the cable grommet, then you can route the cable how you need to from there. This will help keep it out of the pinch points.
John

[tav]

Thx ....just cant get it with my fingers.

[Wayne P.]

no ......the t/m ducer that raps around the t/m. took awhile but i
found the number xnt 9 20 t. alls it shows that its for a transom
ducer .......how do you convert that to a bow ducer?
don't see any pipe clamp set ups.

The 2D Humminbird transducer for a trolling motor is XTM 9 20 T. It is a trolling motor puck and comes with stainless steel hose clamps.

[tav]

Picked up that adapter, hooked it up and it works...
Should of thought of this some time ago.....thank all.