20XD

[90 5.0]

i was told water volume not water pressure got it.had 15 pounds of pressure.about even with the pad and no low water pick-up.

On these motors volume makes pressure, UNLESS there is a blockage somewhere letting it build pressure st low volume, then the over heat alarm should go off

[easyman37379]

it was screaming but i didn't hear it until i got stopped.

[minnowlimo]

Wire up you a small light to put on your dash. Some of these guys have done this already. Maybe they can give you some guidance. I need too since my hearing already sucks.

[90 5.0]

Wire up you a small light to put on your dash. Some of these guys have done this already. Maybe they can give you some guidance. I need too since my hearing already sucks.

Thats a pretty good idea, small red led on the graph somehow would work good.

I have an auto meter water temp gauge on the drag boat I need to put one in my bullet also

[minnowlimo]

motor beep
http://www.bbcboards.net/showthread.php?t=23836

Wiring in a light to horn circuit^^

[easyman37379]

LED ordered

[easyman37379]

guys what is the best prop to run on this set-up(all round set up.)

[minnowlimo]

Larry my uncle had this setup years ago and I'm pretty sure he ran a 26 trophy for an all around prop. Think it would run 76? Don't quote me on that though. If you have already tried the others mentioned here you might ask Paul when you get your motor.

[easyman37379]

thanks man will do.

[easyman37379]

got motor back,now the prop trying begins.