Going to be replacing the bench seat in my 1997 R80 sport, has anyone done theirs, will I need to build a platform for it as the original one is open to fuel tank under it.
Going to be replacing the bench seat in my 1997 R80 sport, has anyone done theirs, will I need to build a platform for it as the original one is open to fuel tank under it.
Are you going back with a bench seat or are you going to 2 single seats ? I did my conversion on a 2002, 205vs and it is a little challenging, but very doable and mad a world of difference !! Here's how I did it
http://www.bbcboards.net/showthread....382&highlight=
Added a center coin box from Bass Boat Seats
CoinBox 2 (1008 x 756).jpg
CoinBox 1 (1008 x 756).jpg
Ranger Boats / Mercury Motors
G Loomis Rods / Shimano Reels
Raymarine / MinnKota Ultrex
Garmin / Live Scope Plus
Pepper Jigs / Robo Worms
Troll Bridge / V-T2 Vents
I am putting a new bench seat from bassboatseats.com. Mine is the same way, looks like I will have to put a deck down also, thanks for the post it was very helpful
Just did mine, like getting a new boat.
http://www.bbcboards.net/showthread.php?t=901293
go with carpeted aluminum. Very clean and looks factory. My seat pan is screwed into the front bulkhead lip and the rear deck vertical surface behind seats.
I took some measurements and determined the angle for the bend of the pan and gave it to a fabricator. Costs ranged form $100-$150. 1/8" aluminum. Do yourself a favor and have a front lip on the pan too, it will add rigidity.