Results 1 to 6 of 6
  1. #1
    Member
    Join Date
    Sep 2014
    Location
    Oklahoma
    Posts
    796

    Procraft 210 loading rear to the passenger side

    Anyone have any idea why my procraft 210 is loading sideways? The bunks are new, but it would do this before I changed them. The rear of the boat gets over by the fender no matter what ramp I use. It used to just go straight on. I figure a bunk needs adjusted, but I wasn't sure which one.

  2. Electrical/Wiring/Trolling Motors Moderator CatFan's Avatar
    Join Date
    Jun 2004
    Location
    SW Indiana
    Posts
    26,089
    #2
    You are too deep with the trailer. By the time the back of the boat gets to the trailer, the front shouldn’t be floating anymore so the boat can’t twist.
    If you have integrity, nothing else matters. If you don't have integrity,
    nothing else matters.​

  3. Member
    Join Date
    Sep 2014
    Location
    Oklahoma
    Posts
    796
    #3
    No I am not too deep. Ive loaded it for years just fine. Even tried barely having it in the water with fenders further out. Still does it.

  4. Member fishnfireman's Avatar
    Join Date
    Apr 2005
    Location
    Amarillo
    Posts
    12,444
    #4
    I would start by taking some measurements at the rear of the trailer -- find center and check the bunks for equal distance.
    Have also seen some adjustable fenders that were bent or had slipped, so measure them from center line also..

  5. Member
    Join Date
    Apr 2012
    Location
    Insomnia, near Seaford Delaware
    Posts
    35,511
    #5
    Some (my) bunks can slip. When you have the boat off look at them.

  6. Electrical/Wiring/Trolling Motors Moderator CatFan's Avatar
    Join Date
    Jun 2004
    Location
    SW Indiana
    Posts
    26,089
    #6
    Take a picture of the boat/trailer from low and behind. Somebody with a similar boat can look at it and compare.
    If you have integrity, nothing else matters. If you don't have integrity,
    nothing else matters.​