I have a 98 Stratos Trail trailer and the tires have began to start wearing on the inside edge. I'm suspecting loss of camber in the axle. My question is can Camber be put back in the axle and it hold? I ask because my axle is square tubing with a 4 inch drop and i can't find square tubing drop axles anywhere. Only round ones. I am assuming if I make the switch to a round axle i will have to change my leaf springs too. Axle is 81 inches hub face to hub face.
Crawl underneath and look for a tag on the axle. That will point you to the specs.
Yes the axle can be bent back to set the camber right. Check the specs before you even look into it so you are sure the axle isn’t overloaded.
You shouldn’t have any trouble finding a square tube axle.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
probably made by ez-loader, give them a call.
Isn't that a "torsion bar" trailer??? The torsion bushings may be shot. Makes sense if the wear is on the inside.
2017 Phoenix 819
2016 200ProXS, s/n 2B359849, Mod 1200P73BD
Reply With Quote