Remote drain plug O Ring size

[bbbill]

need to replace my O ring. Anyone know the size?

[gabes1]

Mine was leaking in water and I just ordered a few from Flo Right. They manufactured the remote drain plug and might have the size on their website.

[RTex]

Mine was leaking in water and I just ordered a few from Flo Right. They manufactured the remote drain plug and might have the size on their website.

never done it, but can you replace the o-ring without removing the whole assembly?

[tdcoleman]

https://flow-rite.com/products/marin...dware/md-00202

here is a link to order the O ring

[gabes1]

Remove two small screws on the plug and take off. Put the new o ring on the plug and center the wire that goes in the plug. Tighten the screws and you are done. Did mine last night and took about 10 minutes.

[RTex]

Remove two small screws on the plug and take off. Put the new o ring on the plug and center the wire that goes in the plug. Tighten the screws and you are done. Did mine last night and took about 10 minutes.

I'm in a lift right now, would it be crazy to try this? I figure I could just sit on a plank over the water and do it but how easy was it?

[like2fish2]

Are these available at auto parts store or Home Depot/Lowe's?

[Lape0019]

The specs are in the link that tdcoleman posted so as long as you can find the same one at a store, you should be set. Now, that doesn’t mean that the runner used will be the same but you can at least get the same size.

[bbbill]

Anyone know if the 0.75 x 0.75 in spec is OD or ID?

[Ranger519VS]

I replaced mine a time or two by matching it up with O rings at Ace Hardware. Don't remember the diameter. I just stretched it over the end of the plug without removing the plug. Took a minute to do. Use a little lube