Originally Posted by
Wendy lou
Talked with my mechanic
he is getting me a remanufactured clock assembly
new sleeves, crank, rods, pistons everything
I am looking at having him install Carson composite reeds
to help acceleration on bottom and mid range
also putting a Bob’s exhaust tuner on it to help it breathe a little better
any experienced with these?
If this is your only concern, get higher compression heads. By far the best bang for the buck. Increased compression and/or reprograming will require 91 octane fuel
klrbee has a lot of good info that would apply in your case
Contact Eric Simonson about reprograming.
Simon Perfomance Technology
1900 Joe Crosson Dr.
El Cajon CA 92020
760-440-9334
Exhaust and intake change may actually hurt the bottom end torque
In all case the boat setup should be done first, there a lot of good info on this site that can help you