-
Hub Kit fpr a 24 Tempest
What is the proper hub kit for a 24 Tempest to 150HO Etec G2?
-
Bought this for my new 150 HO G2, running a 25 Tempest+.
http://www.midwestprops.com/quicksil...rude-e-tec-g2/
-
Thanks. That's the same one i have and i have a 1/4" gap between the step of the prop and the lower unit lip. If that make sense. Just seems too wide. How's the 25 tempest working out.
I have one from my last boat but didn't think it would have the hole shot.
-
So far so good but with the torque of the 150 HOG2 I’m thinking the 25 Tempest+ needs more cup. The Tempest is a larger diameter prop than a Raker. My setup has roughly the same dimension as yours between the prop hub step and lower unit lip. I’m running two small hole vents and none on the other holes.
-
What kind of speed you getting with the 25? I ran the 24 last night and played with the plate from 3- to 3.25 P to P and best i could get was 59-60 at 5970 RPM. Want to pick up a couple more MPH and get the RPM down around 5800 if possible.