-
What a shitty day
Well I for sure have 2 issues going on. My trim quit working right as I pulled the boat out of the water and have water getting into my lower unit after just getting the lower unit seal replaced 2 weeks ago.
As I was looking it over, I noticed a 1.5"-2" crack on the top of my engine block that spider webs out. I'm able to get my fingernail partially inside of it if that helps for a reference Is this potentially a serious issue? I'll try and get a photo posted later as a reference
Last edited by liljakec; 04-21-2018 at 06:43 PM.
-
SC Club Moderator
Would be even better if we knew the motor and model number to assist you.
-
Motor is a 1996 Evinrude Vindicator 200hp
I can't get the photo to load as the file size is too large
-
SC Club Moderator
Open it up with Paint and resize it to 800X600 pixels.
-
SC Club Moderator
If you can't do that you can email it to me, my email is in my profile.