Results 1 to 3 of 3
  1. 04-19-2018, 12:41 AM #1
    SAWDOCTOR
    SAWDOCTOR is offline
    Member
    Join Date
    Apr 2018
    Location
    Wangaratta, Australia
    Posts
    3

    Help with a Triton TR186 setup

    Just repowered my 2006 TR186 with a 2018 Yamaha F175 and would like some guidance with engine height and prop selection. It has a 10” manual Jack plate, I also have a 6” plate that came with the boat. Any help would be greatly appreciated. I live in Australia, and there is not a lot of information available here. Thanks Mick.
    Reply With Quote Reply With Quote
  2. mdtritn21
    mdtritn21 is offline
    Member
    Join Date
    Jan 2005
    Location
    Red Oak Va.
    Posts
    10,597
    #2 04-22-2018, 05:28 PM
    Start at 3" under and raise it up 1/4" at a time until you gain rpm's but not speed, lose bow lift or water pressure then back it down 1/4 and run it.
    Reply With Quote Reply With Quote
  3. SAWDOCTOR
    SAWDOCTOR is offline
    Member
    Join Date
    Apr 2018
    Location
    Wangaratta, Australia
    Posts
    3
    #3 04-22-2018, 05:57 PM
    Thank you, Im going out this morning, so I'll set it at that and see how it performs. Thanks again
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »