I have a 1995 2.5 promax. It has been drilled just above the lower unit. I was looking at it to see about plugging those holes. Can the holes be plugged with out pulling the lower and mid?
I have a 1995 2.5 promax. It has been drilled just above the lower unit. I was looking at it to see about plugging those holes. Can the holes be plugged with out pulling the lower and mid?
don't think so, talented welder mabe, still need to plug up inner bucket, promax needs to breath
.................................................. ...the scariest thing in life is the unknown ...................................
You can smear em full of silicone. We tapped those holes once to have removable screws, but the mid was apart.
1995 Allison XB-2003 225 Super Mag. It's slow and I'm ok with that.
Well my lower unit went out and in the process of fooling with it I decided to plug the 10 holes drilled into my mid section. Took some sand paper to the inside and the some brake cleaner. Then I got a pack of quick steel (jb weld?) and pressed into tjecholes. Two trips to the lake and so far so good.
Mite be able to screw a threaded plug into it? I ran a tap in my mid while was apart , and now I can use a pipe plug loctited in if it gets to loud
Reply With Quote