I have a new to me 2009 Lund Explorer Sport. The dealer put the 83/200 ducer on a board that also houses the LSS2 ducer. The problem is that the depth readings stop when the boat reaches 30-32 MPH. Any ideas? Thanks for your input.
I have a new to me 2009 Lund Explorer Sport. The dealer put the 83/200 ducer on a board that also houses the LSS2 ducer. The problem is that the depth readings stop when the boat reaches 30-32 MPH. Any ideas? Thanks for your input.
Maybe post a picture from the back. Could be too high, too low or there could be something in front of it creating bubbles.
If you have integrity, nothing else matters. If you don't have integrity,
nothing else matters.
Have you tried reading the depth from the down down imagining on the LSS2? I can read mine at a much higher speed than the sonar ducer
I try to drive as if my 16 year old Grandson is following me
Speak as if he is listening and act as if he is watching
How high a speed can you read depth on your LSS2? I moved the 83/200 ducer today lower and picked up a few mph, but it still cuts out. I have rivets across the bottom of the transom that may be the problem. Any thoughts on how to shield the ducer from the turbulent water they cause? Thanks!
Reply With Quote