Results 1 to 3 of 3
  1. 04-05-2018, 10:08 AM #1
    RW outdoors
    RW outdoors is offline
    Member
    Join Date
    May 2014
    Location
    Arizona
    Posts
    7

    2008 200 elite aerator pump switch help

    When I run my aerator pump in auto mode on the port side it runs fine until I run the big motor to change spots. When I do the both lights start to blink and I have to reset the switch to get the pump running again. Has anybody had this problem? Ideas?

    Thanks
    Rick
    Reply With Quote Reply With Quote
  2. Tx Champ
    Tx Champ is offline
    Born on th Llano Estacado Tx Champ's Avatar
    Join Date
    Jun 2004
    Location
    Abilene, TX
    Posts
    20,836
    #2 04-05-2018, 10:50 AM
    May be an early warning of a failing pump. But first, I would make sure the primary wiring for the MegaLink was clean and tight on the battery posts and the breaker. Check the condition of your cranking battery as well with a good float type hydrometer. Also check the connectors on the MegaLink control unit and make sure no corrosion has started.
    Reply With Quote Reply With Quote
  3. RW outdoors
    RW outdoors is offline
    Member
    Join Date
    May 2014
    Location
    Arizona
    Posts
    7
    #3 04-05-2018, 10:52 PM
    I should add that the other pump works with out an issue
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »