Thread: Rig hole?

Results 1 to 4 of 4
  1. 03-14-2018, 10:11 PM #1
    GEEBASS2000
    GEEBASS2000 is offline
    Member
    Join Date
    Oct 2007
    Location
    Marcy, NY
    Posts
    890

    Rig hole?

    So next week I'm dropping off my 2018 Phoenix 721 With a 10inch set back Atlas hydro jack plate to the marina to have them rig it with a Honda BF250. My question is what rig hole should I have them mount it on??
    Reply With Quote Reply With Quote
  2. Hickory Legend
    Hickory Legend is offline
    Honda / Raymarine Moderator Hickory Legend's Avatar
    Join Date
    Jun 2004
    Location
    Old Hickory
    Posts
    10,928
    #2 03-16-2018, 10:15 PM
    I believe mine 721 had the engine mounted on the second hole up. They like to run high.
    Try a 25 fury or Tempest with the vent hole plugged, to start.

    Hopefully Ray will chime in and to set you straight on it.

    My legends the 250 was mounted on the center hole.
    Reply With Quote Reply With Quote
  3. HondaRay
    HondaRay is offline
    Member
    Join Date
    Jun 2004
    Location
    Lawrenceburg
    Posts
    1,277
    #3 03-17-2018, 06:12 PM
    If on a hydraulic jack plate start at the third hole.
    Reply With Quote Reply With Quote
  4. GEEBASS2000
    GEEBASS2000 is offline
    Member
    Join Date
    Oct 2007
    Location
    Marcy, NY
    Posts
    890
    #4 03-18-2018, 12:31 AM
    Thank you Ray. So I assume that is the 3rd hole from the top down? This would leave 2 open holes above the bolts and one below the bolts open??
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »