I will be posting this under FAQ on my website soon, but until then I will pin it to the top of this forum.
The 2018 Bluetooth Talons come with two remotes. These remotes are already paired to the Talon they come with. However, if you install two talons, the Talons will need to be paired with each other. Once paired with each other, and the starboard side is recognized, all 4 remotes will work with both Talons.
To pair the Talons:
run the talons up then down using the keypad on the Talons. this insures the Talons are in the full up position
on one of the Talons, hold the up and down buttons in until it begins to flash, release and quickly repeat the process on the other Talon. If they go for apx 20 seconds and you hear a tone, they did not pair and timed out. repeat the process. When paired you will get 3 quick beeps. If they time out the second time, it means the bluetooth "slots" are filled (happens some times from the factory). To clear, disconnect power. With power disconnected, hold the up button on one of the Talons and reconnect power. The talon will beep and display a light. Repeat the process with the other Talon. The Bluetooth ports are not cleared and the remotes will not longer work. Program two remotes to one, two remotes to the other by (on each remote) holding the up and down arrow buttons down while doing the same on the Talon until you hear the beeps. Repeat for each remote. Now you can pair the Talons according to the directions above.
John