Electric system

[Jetboy]

Does anyone have a electric layout for a 2017 puma? What I’m really looking for is the power panel canon plug layout.
My issue is that half of my panel isn’t working. NAV , wells, fuel all will not work on main panel. horn, and bilge pump work fine.
there must be 2 hots that power this plug and panel.
One that I’m not getting power to.

[SCOTT196]

Richard in parts can send you one! May have a bad switch panel.

[Jetboy]

He did ... I got it yesterday. It didn’t fix it. So I’m still looking. I was just hoping someone knew the wires so I can work on it today.
otherwise I’ll call him tomorrow. And return his panel.

[Bass Cat Boats]

He can provide a plug location pin position sketch.

[sebastien68]

Richard in parts can send you one! May have a bad switch panel.

hmmm Im having the same issue. Before to access anything else then the blidge and horn I needed to have the key at on. now that i switch engine it doesn't work.

[Jonestrollingmotor]

Before tracing anything else, go back to the junction strip on the inside of the transom, take each one loose and clean (I know, they look clean). This has resolved many issues with the touch pad.
John

[Jetboy]

I’ve been working to much and fishing, still havnt started my troubleshooting. Maybe this weekend. Thanks for the info mr Jones.

[champion jon]

cleaning junction strip fixed the same problem for me.

[Phisherman]

Okay, 2017, its under warranty. Why are you wasting your time.

[MDBASSNPRO]

Agree warranty if you don't have the time. However, I have 2005 and needed to clean my power connections on the strip like mr jones said. My pad did the same thing end of last year. There should also be is a jumper between the two red hot wires. You can take multimeter to ground and check if the red wires are each hot.

[Jetboy]

Just a follow up. Thanks to all that replied here. I did all of the above. Richard did send me a new panel. That was what the problem was. But I also got the electrical system much cleaner, and on bus bars in the prosses. I’m now considering a jump start switch and connection to start off my 1st in series trolling battery. ( still in study and research mode).

Thanks so much to Richard and Bass Cat! I had what I need in just a few days. I just got busy and didn’t get the time to fix and trouble shoot tell today. The Cat is clean, full of Gas and back on the lift.