721 console dual graphs help

[Phoenix#1]

Question can I order just the shroud from phenoix for the driver console. I have a single 12 but plan to run dual 12 side by side at console. I see they make one that has the gauges that are below where the graphs will be so you can see them. Anyone have any idea what they cost? Also I can the old gauges be reused or will the new shroud have new gauges? Is this simple such as plug and play for the gauges? Thanks guys

[Tom Edwards]

yes

350 or so

don't know about the gauges fitting

[kry29]

The gauges will depend on which ones you have. They made a large gauge set and a small gauge set. The small gauge set is what fits the new console

[Phoenix#1]

Is a 2018 model. I think they are small gauges

[Phoenix#1]

Also how much is the dual mount and what do you all recommend ? Bassboat technologies or percision sonar? How much do they cost?

[Wackyjig]

Also how much is the dual mount and what do you all recommend ? Bassboat technologies or percision sonar? How much do they cost?

Alot of people are just mounting to the dual mount shroud using the factory gimbals. That's what I've done.

[Phoenix#1]

Alot of people are just mounting to the dual mount shroud using the factory gimbals. That's what I've done.

Any pics

[Phoenix#1]

I will have a helix 12 and a HDs 12 side by side

[Tom Edwards]

http://www.bbcboards.net/showthread.php?t=865311

[Phoenix#1]

Thanks I was asking for pics of dual mounted graphs attached to the shroud without a aftermarket mount. I would like to save 500 if I can lol

[Tom Edwards]

I believe those are factory gimbals. It might say so in that thread, I'm watching Olympic hockey gold metal, so I can't read it.

[kry29]

They would look exactly the same, just without the aftermarket mount. Same positions and all. If going with factory mounts, or any mount, I always make a little backing plate for the bolts. You can just get some aluminum angle from lowes to make it. And since I always overdo it, I would make a little brace from the center of each mount to the back of the shroud for stability. Also out of some aluminum flat bar from lowes.

[Phoenix#1]

Looks to be a flat bar like a precision sonar in the pics I see

[Tom Edwards]

Probably for a little more support under the gimbals for a sturdier mount on the plastic shroud.

[Jeff from Iowa]

They would look exactly the same, just without the aftermarket mount. Same positions and all. If going with factory mounts, or any mount, I always make a little backing plate for the bolts. You can just get some aluminum angle from lowes to make it. And since I always overdo it, I would make a little brace from the center of each mount to the back of the shroud for stability. Also out of some aluminum flat bar from lowes.

my factory shroud had alum plates glued to the back of it

[kry29]

my factory shroud had alum plates glued to the back of it

Well there you go. That would work

[Wackyjig]

my factory shroud had alum plates glued to the back of it

Yep, they have 3 plates secured under the flat on the shroud so you can set up for one graph in the center or one on each side for duals

[Jeff from Iowa]

I assume those are there to screw the gimble down, thats how mine was done by the dealer, I drilled holes and bolted the gimbles thru everything

[Hunter689 / Get Outdoors]

I assume those are there to screw the gimble down, thats how mine was done by the dealer, I drilled holes and bolted the gimbles thru everything

That is correct. No need for aftermarket mounts with the new shroud.